User's Manual

GT-80-40Y
MOTORIZED SLIDER
Add: 338 N Canal St, #20, South San Francisco,CA94080, USA
Web: www.gvmled.com
Email: [e-mail]
2
Step3：Mount slider on the tripod.The screws hole(1/4 and
3/8)on the bottom of plate can directly matched with the
screws on the tripod.
Step2:According to camera instrument’s located hole’s size to
select the camera base to connect screws,and then tighten.
Loosen the camera base lock piece,photograph can be perfect, as
shown in the exhibit.
Install step：
Step1:
From portable bags take the track component and the two
supporting feet component out.Aim screw of support legs to the
screw hole slider both sides and then to lock and tighten the
screw down from above.
4
3
4
1
6
5
2
1
1
F
our: The slider with wheels.
Rapid transformation with the
Product Detail
1.Supporting feet
2.Wheel
3.Bubble level
4.1/4 or 3/8 screw
5.Brake
6.1/4 or 3/8 screw
block and track function. Move the knob to change the model
between block and track
conwenient to use.Using precision thread to adjust foot brace
up and down,it can make slider more level,to achieve a higher
quality.
Three：It is humanized design and suitable for various,especially
Two
：
Camera base and slider reserve all kinds of holes,can
be arbitrary collocation with a variety of photographic equipment.
Introduction：
Moving slider is a collection of camera track and handle push
function. Can be used on the ground, table or tripods to makes
Low Angle shot and tight shot. Rapid transformation with the
block and track function. Move the knob to change the model
between block and track, also you can adjust the levelness with
the knob too. With high quality bearing, make it moves smoothly
and quietly.
The characteristics:
One
：
It has four bearings and perfect mechanics principle,can
carry more and Slide smoo ther.