Data Sheet

GETTING STARTED
19
RS232 Interface
Port
The RS232 port is used for remote
control.
USB B-Type
Interface Port
The USB B-Type port is used for
remote control.
SIGNAL I/O port
The SIGNAL I/O port is used to
monitor the tester status (PASS,
FAIL, TEST) and input (START/
STOP signals).
INTERLOCK
Terminal
The INTERLOCK terminal is used
to connect with interlock wire for
safety operation.
TEST OUTPUT
switch
When SIGNAL I/O is utilized,
depending on the applied device, it
can be toggled between power
symbol and contact symbol.
Contact symbol
Power symbol
Fan/Fan Vents
Exhaust fan. Allow enough room
for the fan to vent. Do not block the
fan openings.
HIGH VOLTAGE
Indicator
The HIGH VOLTAGE indicator will
light up when an output terminal is
active. Only after the test has
finished or stopped will the lamp
turn off.