Data Sheet

GPT-9500 Series User Manual
40
MANU Tests
This section describes how to create, edit and run ACW, DCW and
IR manual tests. Each MANU setting described in this chapter only
applies to the selected manual test – no other manual tests are
affected.
Each manual test can be stored/recalled to/from one of 501
memory locations. Each stored manual test can be used as a test
step when creating an AUTO test (page 90).
 Choose/Recall a MANU Test Number → from page 41.
 Setting the MANU Test Mode → from page 43.
 Setting the Test Voltage → from page 44.
 Setting the Ramp UP Time → from page 45.
 Setting the Test Time → from page 47.
 Setting the Upper and Lower Limits → from page 50.
 Setting the ARC Detection → from page 52.
 Setting a Reference Value → from page 53.
 Setting the Scan Arrangement → from page 55.
 Creating a MANU Test Name → from page 57.
 Setting the Wait Time → from page 59.
 Setting the Fall Time → from page 61.
 Setting the Grounding Mode → from page 63.
 Setting the IR Test Range → from page 66.
 Setting OFFSET reference value → from page 67.
 Viewing the Parameters Settings → from page 69.
 Setting the Pause (PA) Step → from page 71.
 Setting the Open Short Check (OSC) Step → from page 74.
 Copy a MANU step → from page 77.
 Clear the MANU tests state → from page 79.
 Set the Panel Key Lock → from page 80.
 Running a MANU Test → from page 82.
 PASS / FAIL MANU Test → from page 86.