Manual
Manuals
Brands
GW Instek Manuals
Laboratory Equipment
GSP-730 Manufacturer's standards (no certificate)
101
102
103
104
105
106
107
108
109
110
Table Of Contents
SAFETY INSTRUCTIONS
Safety Symbols
Safety Guidelines
Power cord for the United Kingdom
GETTING STARTED
GSP-730 Introduction
Main Features
Package Contents
Appearance
GSP-730 Front Panel
Rear Panel
Display
First Time Use Instructions
Tilting the Stand
Power UP and Down
Software Update
USB Driver Installation
Restoring Default Settings
Conventions
BASIC OPERATION
Frequency Settings
Center Frequency
Start and Stop Frequency
Center Frequency Step
Span Settings
Span
Full Span
Zero Span
Last Span
Amplitude Settings
Reference Level
Amplitude Units
Scale/Div
Autoset
Using Autoset
Limiting the Autoset Vertical Search Range
Limiting the Autoset Horizontal Search Range
Marker
Activating a Marker
Activate a Normal Marker
Activate a Delta Marker
Move Marker Manually
Move Marker to Preset Locations
Move Marker to Trace
Turn All Markers On or Off
Show Markers in Table
Peak Search
Move Marker to Peak
Move Marker and Peak to Center
Search for Peaks
Peak Table
Measurement
Channel Analysis Overview
ACPR
OCBW
Limit Line Testing
Activate a Limit Line
Creating a Limit (Point by Point)
Pass/Fail Testing
Bandwidth
Resolution Bandwidth Setting (RBW)
Trace
Selecting a Trace
Trace Math
Average Trace
Display
Adjusting the LCD Brightness
Setting a Display Line (Reference Level Line)
Using the Video Out Port
Split Spectrum View
Save/Recall Files
Save/Recall Setup
Save/Recall Trace Data
Save/Recall Limit Lines
Saving an Image File (Hardcopy)
Hardcopy Setup
Load Default Settings
System Settings
System Information
System Language
REMOTE CONTROL
Interface Configuration
Configure Remote Interface
Remote Control Function Check
Command Syntax
Command List
IEEE488.2 Standard Commands
Sweep Commands
Frequency Commands
Span Commands
Amplitude Commands
Marker and Peak Search Commands
Trace Commands
Power Measurement Commands
Limit Line Commands
BW Commands
Display Commands
Preset Commands
System Commands
FAQ
I connected the signal but it does not appear on screen.
The trace is updated too slowly on the screen.
I cannot see the trace on the screen.
The performance does not match the specification.
APPENDIX
GSP-730 Default Settings
GSP-730 Specifications
Frequency
Amplitude
Sweep
General
Other
GSP-730 Dimensions
INDEX
GSP-730 User Manua
l
106
F
ull Display: Active
Display line: off
Memory
N/A
Preset
N/A
Hardcopy
N/A
Hardcopy Setup
Ink Normal
System
N/A
1
...
...
106
107
108
109
110
...
...
114
