Instructions

ANALOG CONTROL
127
Note
The Ext-R configuration is recommended for
safety reasons. In the event that the cables become
accidentally disconnected, the current output will
drop to zero. Under similar circumstances using
Ext-R , an unexpected high current would be
output.
If switches are used to switch between fixed
resistances, use switches that avoid creating open
circuits. Use short-circuit or continuous resistance
switches.
Connection
PSWEXT-R
Analog
connector
8
9
Output
Terminal
2 core shielded
wire or twisted
pair
 Pin9 → EXT-R
 Pin8 → EXT-R
 Wire shield → negative (-) output terminal
Steps
1. Connect the external resistance according to the
connection diagrams above.
1. Set the F-91 (CC Control)
configuration settings to 2 for Ext-
R
or 3 for Ext-R .
Page 114
 Be sure to cycle the power after the power
on configuration has been set.
2. Press the Function key and confirm
the new configuration settings (F-
91=2 or 3).
Function