User Manual Manual
MODULATION
121
Range
Frequency
1uHz~25MHz
Freqency – Ramp
1uHz~1MHz
Default
1kHz
Note
Waveform frequency and burst period are not the
same. The burst period is the time between the
bursts in N-Cycle mode.
Burst Cycle/Burst Count
The burst cycle (burst count) is used to define the number of cycles
that are output for a burst waveform. Burst cycle is only used with
N-cycle mode (internal, external or manual source). The default
burst cycle is 1.
Panel Operation
1. Press the Burst key.
2. Press F1 (N Cycle).
yl
3. Press F1 (Cycles).
yls
4. The Cycles parameter will become highlighted
in the Waveform Display area.