User Manual Manual

REMOTE INTERFACE
233
SOURce[1|2]:PM:STATe
Source Specific
Command
Description
Turns PM Modulation on or off. By default PM
modulation is off.
Note
Burst or sweep mode will be disabled if PM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when PM modulation is enabled.
Syntax
SOURce[1|2]:PM:STATe {OFF|ON}
Example
SOUR1:PM:STAT ON
Enables PM modulation
Query Syntax
SOURce[1|2]:PM:STATe?
Return Parameter
0
Disabled (OFF)
1
Enabled (ON)
Example
SOUR1:PM:STAT?
1
PM modulation is currently enabled.
SOURce[1|2]:PM:SOURce
Source Specific
Command
Description
Sets or queries the PM source as internal or
external. Internal is the default source.
Note
If an external PM source is selected, the phase
modulation is controlled by the MOD INPUT
terminal on the rear panel.
Syntax
SOURce[1|2]:PM:SOURce {INTernal|EXTernal}
Example
SOUR1:PM:SOUR EXT
Sets the PM source to external.
Query Syntax
SOURce[1|2]:PM:SOURce?
Return Parameter
INT
Internal
EXT
External