User Manual

SCANNER (OPTIONAL)
79
Setup Scan
Overview
Scan type Simple
Sets the scanned channel range, loop
count, and timer length. All channels
have a common measurement item.
Advanced
In addition to the above Simple Scan
setting, allows custom setting for each
channel, such as measurement item,
range, and rate.
Timer setting
Sets the duration between each scan loop (Scan
operation) or between each scanned channel (Step
operation).
Count setting
Sets the number of scan operation (loop).
Trigger setting Internal
(Continuous)
The GDM-8200A series keeps triggering
continuously until the scan reach the end
of loop count. Then it goes into the idle
mode.
External
(Manual)
The GDM-8200A series stays in the idle
mode by default. The trigger timing is
manually controlled by the user from the
front panel (TRIG key).
Scan operation Scan
Measures all specified channel range at
each trigger event. Timer setting (page80)
applies between each scan (the whole
channel range).
Step
Measures a single channel in the specified
range at each trigger event. Timer setting
(page80) applies between each channel.
Monitor
Selects just one channel and continuously
measure it.