User manual

GDM-834X Series User Manual

102

Configure Remote Control Interface

USB Interface

The USB device port on the rear panel is used for remote control.

The USB port on the DMM will appear as a virtual COM port to a

connected PC. Any terminal program that can communicate via a

serial port can be used for remote control. Before the DMM can be

used for remote control the USB driver included on the User

Manual CD, must first be installed.

USB

configuration

PC connector

Type A, host

DMM connector

Rear panel Type B, slave

Speed

1.1/2.0 (full speed/high

speed)

Selectable baud rate

9600, 19200, 38400, 57600,

115200

Parity

None

Hardware flow

control

Off

Data Bits

Stop bit

Steps

1. Connect the USB cable to the rear panel type B

USB port.

2. Press MENU.

3. Go to I/O on level 1.

4. Go to USB on level 2.

5. Set the baud rate to an applicable rate.