Manual

GDS-1000-U Programming Manual
40
Go No-Go Commands
:GONogo:CLEar ........................................................... 40
:GONogo:EXECute ...................................................... 41
:GONogo:FUNCtion .................................................... 41
:GONogo:NGCount? ................................................... 42
:GONogo:NGDefine .................................................... 42
:GONogo:SOURce ...................................................... 42
:GONogo:VIOLation ................................................... 43
:TEMPlate:MODe ........................................................ 43
:TEMPlate:MAX ........................................................... 44
:TEMPlate:MIN ............................................................ 45
:TEMPlate:POSition:MAX ............................................ 45
:TEMPlate:POSition:MIN ............................................ 46
:TEMPlate:SAVe:MAXimum ........................................ 47
:TEMPlate:SAVe:MINimum ........................................ 48
:TEMPlate:TOLerance.................................................. 48
:TEMPlate:SAVe:AUTo ................................................ 49
:GONogo:CLEar
Set
Description
Clears the Go No-Go test result ratio.
This is the equivalent to clearing the “failed” to
“total tests” result ratio as shown in the Go-NoGo
menu.
Same as: Utility key → More (F5) →Go-NoGo
Menu(F1)→Ratio:(F5).
Note
Before any Go-NoGo command can be used,
please use the :GONogo:FUNCtion 1 command to
initialize the oscilloscope.
Syntax
< Long >
< Short >
:GONogo:CLEar
:GON:CLE