User Manual User Manual

GETTING STARTED

Setting up the Oscilloscope

Background

This section describes how to set up the

oscilloscope properly including adjusting the

handle, connecting a signal, adjusting the scale,

and compensating the probe. Before operating the

oscilloscope in a new environment, run these steps

to make sure the oscilloscope is functionally stable.

Procedure

1. Pull both bases of

the handle out

slightly.

2. Turn to one of the three

preset positions.

3. Connect the power cord.

4. Press the power switch. The

display will become active

in approximately 10

seconds.

5. Reset the system by recalling

the factory settings. Press

the Save/Recall key, then

Default Setup. For details

regarding the factory

settings, see page 43.

Default

Setup

Save/Recall