User Manual User Manual

CONFIGURATION

Rear Panel USB Port Interface

The Remote control interface section describes how to set up the

USB interface for PC connection. The details of remote control

commands are described in the GDS-1000-U Programming Manual.

USB connection

PC end

Type A, host

GDS-1000-U end

Type B, slave

Speed

1.1/2.0 (full speed)

Procedure

1. Connect the USB cable to

the USB slave port on the

GDS-1000-U.

2. When the PC asks for the USB driver, select

dso_cdc_1000.inf which is downloadable from

the GW website, www.gwinstek.com.tw, GDS-

1000-U product corner.

3. On the PC, activate a terminal application such

as MTTTY (Multi-Threaded TTY). To check the

COM port No., see the Device Manager in the

PC. For WindowsXP, select Control panel →

System → Hardware tab.

4. Run this query command via the terminal

application.

*idn?

This command should return the manufacturer,

model number, serial number, and firmware

version in the following format.

GW, GDS-1052-U, 000000001, V1.00

5. Configuring the command interface is

completed. Refer to the programming manual

for the remote commands and other details.