Manualshelf

Manual

ManualsBrandsGW Instek ManualsEquipmentGDS-2000 training manual
31323334353637383940
GDS-2000 Series Training Manual
36
GLA-1000 Demonstration Setup
Follow the below steps to properly power up and connect the demo
board. This section assumes you already have GLA-1000 application
software, together with GLA driver, installed in your PC.
1. Connect GLA to the PC, press the power switch to power it up.
The POWER LED on GLA turns on.
2. The demo board can be connected to GDS-2000 rear panel USB
connector, or to the PC.
3. Connect GLA and demo board as in the following diagram.
Connect both 2 GND pins for secure grounding.
SDA
SCL
Tx
Rx
SCK
SS
Gnd
LA 0
LA 1
LA 2
LA 3
LA 4
LA 5
LA 6
LA 7
T_0
Gnd
MOSI
MISO