User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
71
When
Pulse width (10ns - 10s)
Standard
NTSC
National Television System
Committee
PAL
Phase Alternate by Line
SECAM
SEquential Couleur A Memoire
Trigger On
Field1
Sets the trigger point to a line on
field1 (odd).
Field2
Sets the trigger point to a line on
field2 (even).
All Fields
Trigger on all fields.
All Lines
Trigger on all lines.
Trigger Mode
Background
The trigger mode can be set to Normal or Auto
(untriggered roll). The triggering mode applies
to all the trigger types. See page 69.
From the Trigger menu, set the Mode to Auto
or Normal.