User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
88
–Width
Negative pulse width.
Duty Cycle
Ratio of signal pulse compared
with whole cycle. =100x (Pulse
Width/Cycle)
+Pulses
Measures the number of positive
pulses.
-Pulses
Measures the number of negative
pulses.
+Edges
Measures the number of positive
edges.
-Edges
Measures the number of negative
edges.
Delay Measurement
FRR
Time between:
Source 1 first rising edge and
Source 2 first rising edge.
FRF
Time between:
Source 1 first rising edge and
Source 2 first falling edge.
FFR
Time between:
Source 1 first falling edge and
Source 2 first rising edge.
FFF
Time between:
Source 1 first falling edge and
Source 2 first falling edge.
LRR
Time between:
Source 1 first rising edge and
Source 2 last rising edge.
LRF
Time between:
Source 1 first rising edge and
Source 2 last falling edge.