User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Utility Commands
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Go_NoGo Commands
- Replay Commands
- Rotate Commands
- DMM Commands
- APPENDX
- INDEX
GDS-200 & GDS-300 Programming Manual
90
Run Command
:RUN
Description
The run command allows the oscilloscope to
continuously make acquisitions, equivalent to
toggling the scope to RUN mode (using the
Run/Stop key on the LCD screen).
Syntax
:RUN
Stop Command
:STOP
Description
The stop command stops the oscilloscope making
further acquisitions, equivalent to toggling the
scope to STOP mode (using the Run/Stop key on
the LCD screen).
Syntax
:STOP
Single Command
:SINGle
Description
The single command allows the oscilloscope to
capture a single acquisition when trigger
conditions have been fulfilled (equivalent to
pressing the Single key on the screen).
Syntax
:SINGle
Set
Set
Set