User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
117
Set the Brightness Level
Background
The Brightness menu sets the display
brightness and the display power management,
known as ECO mode. ECO mode turns the
brightness down after a set amount of time
until the display is touched again.
Steps
From the Display menu press Brightness and
select the brightness level and set the ECO
mode time.
Brightness
0 - 100%
ECO Mode
1, 2, 5, 10, 30 minutes
Brightness
Menu
Eco Mode
Settings