User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
120
Max/Min
Individually sets the offset for
the upper and lower templates.
These are based on the ground
level of the source channel.
Auto
Sets the tolerance for the upper
and lower template an equal
distance from the source
channel. This is set to 0.4% by
default.
Save Template
7. To save or recall a template, press the Option
button when in the Template Edit menu.
For the Max/Min option, there are a number of
recall options:
From
Allows you to recall either an
internally saved reference
waveform (Wave 1 - Wave 2),
or to recall a reference
waveform using the file
manager.
To
Recall the waveform to R1
(upper template) or R2 (lower
template).
Recall
Recalls the selected reference
waveform to the corresponding
template.
Save options:
Save Max to R1
Saves the Max template to
reference 1.
Save Min to R2
Saves the Min template to
reference 2.
For the Auto option, there is a single save
option, there is not a recall option: