User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
145
Multimeter Display Overview
The DMM display will show the measurement mode, max, min and
current measurement, and a trend plot (vertical view only) of the last 120
measurements. Please note that in the horizontal view, the DMM display
is only fully shown in the expanded view, see above for details.
Current measurement
DMM mode
Max
Min
Hold on/off
Trend plot
(vertical view only)
AC/DC Voltage Measurement
Background
The GDS-200/300 can measure up to 600V
(CAT II) or 300V (CAT III).
Connection
10A MAX
FUSED
V
W
COMA mA
GDS-220
Digital Storage Oscilloscope
200 MHz 1GSa/s
COM V
W
CAT II 600V
CAT III 300VFUSED
600mA MAX
Steps
1. From the multimeter settings choose ACV,
ACmV, DCV or DCmV.
ACV =
ACmV =
DCV =
DCmV =