User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
146
2. The selected mode will be previewed in the
lower corner.
VAC and VDC keys
Multimeter
settings
Preview screen
3. Press anywhere outside of the multimeter
settings area to return to the main display.
Example
Voltage measurement
DMM mode
Max
Min
Hold on/off
Trend plot
(vertical view only)
Current Measurement
Back Ground
The GDS-200/300 can measure AC and DC
current from two input terminals, depending
on the current range. There is a 10A input for
I≤10A, and a mA terminal for I≤600mA.
Connection
10A MAX
FUSED
V
W
COMA mA
GDS-220
Digital Storage Oscilloscope
200 MHz 1GSa/s
Max 10A
Max 600mA
A COM
mA COM
CAT II 600V
CAT III 300VFUSED
600mA MAX