User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GETTING STARTED
31
6. The battery indicator is shown on the top
right-hand corner of the main display.
USB Driver Installation
Background
The GDS-200/300 has a USB device driver that
should be installed to get the most out of the
unit.
Installation
1. Turn off the GDS-200/300.
2. When the PC is on, connect the USB cable from
the GDS-200/300 to the PC.
3. Turn the GDS-200/300 on.
4. Access the Menu tray by pressing the title bar.
Go to Utility>USB device port and set the
device port to Communication.
5. The PC will now recognize the unit as a new
device and ask to search for the driver.
6. Direct the driver installation wizard to the USB
device driver (dso_vpo.inf) on the User Manual
CD.