User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
41
Gesture Control
This chapter will go over all of the basic touch gestures that are
available using the default settings. The touch gestures cover all the
most frequently used operations that an engineer uses, allowing the
GDS-200/300 to operate completely without panel keys or knobs.
Note
The gestures described below are only applicable if
“Waveform” is selected as the gesture control method.
See page 83 for details.
Select a Channel, Math or Reference Waveform
Background
Any channel, math waveform or reference
waveform that has already been turned on can be
selected from the left of the grid. See page 51 to
turn on a waveform, math function or waveform.
Steps
To select the active waveform, tap the desired
channel, math or reference indicator.
When selected, the icon will become a solid
triangle.
Example
Selected
waveform