User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMAND OVERVIEW
- COMMAND DETAILS
- Common Commands
- Acquisition Commands
- Autoscale Commands
- Vertical Commands
- Math Commands
- Cursor Commands
- Display Commands
- Hardcopy Commands
- Measure Commands
- Measurement Commands
- Reference Commands
- Run Command
- Stop Command
- Single Command
- Force Command
- Timebase Commands
- Trigger Commands
- System Commands
- Save/Recall Commands
- Ethernet Commands
- Time Commands
- Bus Decode Commands
- Mark Commands
- Search Commands
- Digital Commands
- Label Commands
- Utility Commands
- APPENDX
- INDEX
GDS-2000A Programming Manual
160
Parameter/Return
parameter
<NR1>
0: NULL
1: LF (line feed)
2: CR (carriage return)
3: SP (space character)
4: FF
Example
:BUS1:UART:EOFPAcket 2
Sets the OEF character to CR.
:BUS1:UART:TX:SOURce
Set
Query
Description
Sets or queries which channel is used for the
UART Tx source.
Syntax
:BUS1:UART:TX:SOURce { OFF| D0 | D1 | D2 | D3 | D4
| D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 |
D15 | ? }
Parameter/Return
parameter
OFF
Off, no Tx source
D0 to D15
Digital channels D0 to D15
Example
:BUS1:UART:TX:SOURce D1
Sets channel D1 as the Tx source.
:BUS1:UART:RX:SOURce
Set
Query
Description
Sets or queries which channel is used for the
UART Rx source.
Syntax
:BUS1:UART:RX:SOURce { OFF| D0 | D1 | D2 | D3 | D4
| D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 |
D15 | ? }
Parameter/Return
parameter
OFF
Off, no Rx source
D0 to D15
Digital channels D0 to D15
Example
:BUS1:UART:RX:SOURce D1
Sets channel D1 as the Rx source.