User manual

In order to comply with the technical tolerance data, the device has to be operating for

about 30 minutes within the given operating temperature range.

GETTING STARTED

Connect the mains cable provided to the mains connector, at the back of the device, and 1.

connect the Schuko plug to an earthed mains socket.

Switch on the device with the power switch (POWER I/0).2.

The device shows a start screen and is ready for operation after a short initialisation phase.3.

Connect the appropriate measuring cables/probes to the BNC connector of the input 4.

channel(s)

1 or/and 2 (2 channels). -

1 or/and 2, 3, 4 (4 channels). -

The measuring voltage should only be applied to the internal conductor.

The external conductor (reference earth) is connected to the earth potential

(protective earth conductor).

Touch the object to be measured with the probes.5.

To automatically set the signal, push the button AUTOSET. This function sets the time base, 6.

theverticaldeectionandthetriggerlevelautomaticallytooptimisethesignalvisualisation

on the oscilloscope.

Removetheprobefromtheobject,afternishingthemeasurement,andturnoffthedevice.7.

CLEANING

Always observe the following safety instructions before cleaning the device:

Live components may be exposed if covers are opened or parts are removed

(unless this can be done without tools).

Prior to cleaning or repairing of the device, all cables have to be detached and

the device has to be turned off.

Do not use scouring, chemical or aggressive cleaning agents such as benzene, alcohol •

or such like. These might attack the surface of the device. Furthermore, the fumes are

hazardous to your health and are explosive.

Moreover, you should not use sharp-edged tools, screwdrivers or metal brushes or suchlike •

for cleaning.

For cleaning the device or the display and the measuring cables, use a clean, slightly damp, •

fuzz-free, antistatic cloth.

Should questions arise concerning the use of the device, feel free to contact

our technical support at the following phone number:

Voltcraft®, D-92242 Hirschau, Lindenweg 15,

Tel. +49 180 / 586 582 7

DISPOSAL

Electronic devices are recyclable waste and must not be disposed of in the household

waste.

At the end of its service life, dispose of the product according to the relevant statutory

regulations.

Legal notice

These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau

(www.conrad.com).

Allrightsincludingtranslationreserved.Reproductionbyanymethod,e.g.photocopy,microlming,orthecaptureinelectronicdataprocessing

systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.

These operating instructions represent the technical status at the time of printing. Changes in technology and equipment reserved.