User Manual

OPERATION
37
Creating a Test Setup
This section describes how to create, edit and run tests using the
scanner box interfaces. In principal we will be showing you how to
configure the output terminals on the scanner box rear panel. For
the GSB-01, each terminal can be configured as either an HV output
(hereafter referred to as HI) or as a return terminal (hereafter
referred to as LO). For the GSB-02, channels 1 to 6 can be
configured to HI or LO terminals as well. However for channels 7
and 8, the GSB-02 can also configure these channels into pairs of
Source/Sense HI.
Thus each terminal on the scanner boxes must be configured based
on the desired test setup, as referred to in the previous chapter on
page 25.
Note
Setting the test settings, test mode and general
operation will not be discussed in this manual.
Please see the GPT-9000 User Manual for more
operation details.
Before operating the safety tester please read the safety precautions
as outlined in the Safety Considerations chapter on page 18.