User Manual

GSB-01/GSB-02 Series User Manual
44
Running a Manual Test
Background
A test can be run when the tester is in READY
status.
Note
The tester cannot start to run a test under the
following conditions:
 A protection setting has been tripped; when a
protection setting has been tripped the
corresponding error message is displayed on
the screen.
 The INTERLOCK function is ON and the
Interlock key is not inserted in the signal I/O
port.
 The STOP signal has been received remotely.
If Double Action is ON, ensure the START
button is pressed immediately after the STOP
button (<0.5s).
Note
When a test is running the voltage output cannot
be changed, unless the test is under the special
manual mode.
Steps
1. Ensure a MANU test is selected and the tester is
in VIEW status.
I R G B
m A
A CW D CW
E
F R E Q = 0 H z 6
0 100
k V
EIV
MT I E = 0 0 1 . 0 SR
0 0 m AER F =# 0 .0
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
W
VIEW status
MM A UN N A_2M A N U = * * * - 0 0
Selected manual test