User Manual

GSB-01/GSB-02 Series User Manual
54
Running an Automatic Test
Background
Running an automatic test with the GSB-01/02
scanner boxes is the same as running an
automatic test without them.
Note
The tester cannot start to run an AUTO test
under the following conditions:
 Any protection modes have been tripped.
 The INTERLOCK function is ON and the
Interlock key is not inserted in the signal I/O
port.
 The STOP signal has been received remotely.
If Double Action is ON, ensure the START
button is pressed immediately after the STOP
button (<0.5s).
Warning
Do not touch any terminals, test leads or the DUT
when a test is running.
Steps
1. Ensure the tester is in VIEW status.
I R G B A CW D C W
E
F R E Q = 0 H z 6
0 100
k V
EIV
MT I E = 0 0 1 . 0 SR
0 0 m AER F =# 0 .0
1 . 0 0 m AIH ES = 0T
0 0 . 1 S0A M P =R
W
MA U OT N A_0A U T O = 0 0 1 - 1 0
m A
2. Press the STOP button to put the
tester into the READY status.
STOP