User Manual

FAQ
71
FAQ
•
I get a scanner error when I run a test.
•
The tester will stop testing midway through an automatic test.
•
When I press the START button the tester will not start testing?
I get a scanner error when I run a test.
A scanner error indicates that the HV and return terminals haven’t
been properly connected between the safety tester and the
scanner(s).
The tester will stop testing midway through an automatic
test.
You may have PASS HOLD turned on or FAIL MODE set to HOLD.
Press the Start button to continue to the next test. See the user
manual for setting details.
When I press the START button the tester will not start
testing?
The tester must first be in the READY status before a test can be
started. Ensure the tester displays READY before pressing the
START button.
If “Double Action” is enabled, the START button must be pressed
0.5 seconds after the STOP button is pressed, otherwise the tester
will not start testing.