Datasheet

A.
CIRCUIT DESIGN FOR GROUND ISOLATION AMONG OUTPUT/INPUT TERMINALS AND INSTRUMENT CHASSIS
Output channels, synchronization and modulation input/output
connector grounding are isolated from instrument chassis.
These connectors can sustain maximum isolation voltage up to
±42Vpk (DC+ AC peak value) to earth ground that is ideal for
floating circuit tests. Multi-unit outputs can be executed without
factoring in grounding reference issue.
The built-in DC bias voltage of the MFG-2000 series can be
applied on various waveforms. The DC bias voltage is ±5V under
50 ohm load. An external power supply can be used to bring up
the DC bias voltage to ±42Vpk (DC+ AC peak value) for higher
DC bias applications.
( * MFG-2220HM excluded )
Connection diagram for MFG connecting with a power supply
to increase D.C. bias voltage to ±42Vpk (DC+ AC peak value).
RF signal generator is a full function AFG signal source. Identical
to CH1/CH2, it can output sine, square, ramp, pulse, noise, etc.
Its sine wave frequency reaches 160MHz or 320MHz. And its true
point by point output arbitrary waveform function supports
200 MHz sample rate, 100MHz waveform repetition rate, 14 bit
resolution, 16k point memory depth, frequency sweep and various
modulation methods such as AM/FM/PM/FSK/PWM/PSK/ASK.
RF signal generator can be applied as a high frequency arbitrary
waveform generator, simulated signals of analog or digital
broadcast stations or carrier signals of local oscillator.
C.
RF SIGNAL GENERATOR
B.
PULSE GENERATOR
20W/20dB power amplifier, which has a bandwidth of 5Hz~100kHz
and less than 0.1% distortion. The low frequency power amplifier
can be applied as an audio amplifier or a driver amplifier for
piezoelectric components (collocating with an impedance
transformer, 20W output) and conducts power component
characteristics tests, magnetization characteristics tests(B-H curve)
of magnetic materials such as ferrite and amorphous materials
(collocating with an impedance transformer, 20W output)
POWER AMPLIFIER
D.
Users can connect a speaker with the low frequency power
amplifier of the MFG-2000 series to realize various physics
experiments.
Each model of the series has a built-in pulse generator and its
output frequency reaches 25 MHz. Users can set pulse width,
duty cycle, rise edge time, and fall edge time to support trigger
signal.
The pulse width can be fine-tuned to the minimum of 20ns and
the leading/trailing edge times can be set independently to the
minimum of 10ns.