User Manual User Manual

PEL-2000 Series User Manual
76
On end load
If more than one Sequence is programmed on the
mainframe, the On End Load function allows a
Sequence to configure its load on or off at the end
of its sequence until the last sequence ends. After
the last sequence ends, all loads are turned off.
This function is ineffective if only one Sequence is
active. This is as the On End Load time and the
time of the last sequence will be the same.
End of
Sequences
Trig Out
The Trigger Out function allows a trigger sequence
signal to be output from a channel via PIN 4 on
Frame Link connector 1 when using Sequences.
The Trig Out function is used from the Channel
Duration menu.
Point1 Point2 Point3 Point4 Point5 Point6
As can be seen above, a trigger sequence signal is
output for every rising edge point.