User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
49
Query example
:CONFigue:DYNamic?
> Value,T1,T2
The dynamic mode becomes a value setup and timer
setup.
:CONFigure:MEMory
Set
Query
Description
This command configures the how the files are
recalled in local mode (using the front panel
interface). By default when you try to recall a file
or setting from memory, a message will appear
asking you to press the Enter key to confirm each
time you wish to recall. This command enables
(SAFety) or disables this feature (DIRect).
Syntax
:CONFigure:MEMory {SAFety | DIRect }
Query Syntax
:CONFigure:MEMory?
Parameter
SAFETY or SAF
Safety setting.
DIRECT or DIR
Directly recall the chosen
file.
Return parameter
Safety
Safety setting.
Direct
Directly setting.
Example
:CONFigure:MEMory SAFety
Enables the safety setting.
Query example
:CONFigure:MEMory?
>Safety
The safety setting is enabled.
:CONFigure:SHORt
Set
Query
Description
Configures the short key.
Syntax
:CONFigure:SHORt { TOGGle | HOLD }
Query Syntax
:CONFigure:SHORt?
Parameter
HOLD
Sets the button
configuration to hold