User manual
Table Of Contents
- INTERFACE OVERVIEW
- COMMNAND OVERVIEW
- Command Syntax
- Command List
- Common Commands
- Trigger Commands
- Input State Commands
- Measurement Commands
- Configure Subsystem Commands
- Parallel Commands
- Step Resolution Commands
- External Control Commands
- Mode Subsystem Commands
- Current Subsystem Commands
- Resistance Subsystem Commands
- Voltage Subsystem Commands
- Power Subsystem Commands
- Function Commands
- Utility Commands
- File Commands
- SCPI Register Commands
- Status Registers
- Error Messages
COMMNAND OVERVIEW
79
Resistance Subsystem Commands
:RESistance[:VA] .................................................................. 79
:RESistance:VB ..................................................................... 80
:RESistance:SRATe .............................................................. 80
:RESistance:L1 ...................................................................... 81
:RESistance:L2 ...................................................................... 82
:RESistance:SET ................................................................... 82
:RESistance:LEVel ............................................................... 83
:RESistance:RISE ................................................................. 84
:RESistance:FALL ................................................................ 84
:RESistance:T1 ...................................................................... 85
:RESistance:T2 ...................................................................... 86
:RESistance:FREQuency ..................................................... 86
:RESistance:DUTY ............................................................... 87
:RESistance[:VA]
Set
Query
Description
Sets or queries the CR mode “A Value” resistance.
This command is only applicable to static mode.
Note: A different value can be set for each current
range (High/Mid/Low).
Note: The optional command node [:VA] can only be
omitted when in static mode.
Syntax
:RESistance[:VA] {<NRf>[ MHO ] | MINimum |
MAXimum }
Query Syntax
:RESistance[:VA]?
Parameter
<NRf>[ MHO ]
“A Value” conductance
value
MINIMUM or MIN
Minimum conductance
level
MAXIMUM or MAX
Maximum conductance
level
Return parameter
<NR2>
Returns the “A Value”
resistance value.