User Manual

OPERATION

CAUTION

If the output is active at the end of the program as

shown in the figure above, the power supply

output will remain at the level of the last step even

after the completion of the sequence operation.

(I.e., the output stays active.)

The last step number must be set to OFF for the

the output to be turned off at the end of a

sequence.

The sequence operation will end prematurely if

the OUTPUT key pressed when a sequence is

running. Note however, that the output will

remain active at the level of the last step that was

executed when the OUTPUT key was pressed.

Procedure

1. Press the MENU key until menu number

―05‖(PSB-L) or ―4‖(PSB-H) is displayed.

2. Press the ENTER / CHECK key to enter the

sequence operation settings. Select ON or OFF

with the encoder wheel. By default the

sequence function is turned off.

Initial setting

Sequence operation activated

3. Press the ENTER / CHECK key to confirm the

setting.

The SEQUENCE LED below the PRESET key

turns on.

1 2 3