User manual

ManualsBrandsGW INSTEK ManualsLaboratory & Bench PSUs19" bench PSU (adjustable voltage) 0 - 40 Vdc 0 - 38 A 1 x Ethernet, RS232, RS485, USB remote con

OPERATION

83

Note

Ensure load cables have sufficient

current capacity.

Page 39

Series Operation

Series

Configuration

Before using the power supplies in series, the

master and slave units need to be configured.

1. Configure the OVP, OCP and ULV

settings for each unit.

Page 51

2. For each unit, hold the Function key while

turning the power on to enter the power on

configuration settings.

Lock/Local PROT Function Test Set

Output

Unlock ALM_CLR M 1 M 2 M 3

Shift

: Long Push

VSR LAN RMT ERR DLY ALM ISR M 1 M 2 M 3 RUN

C C

A

C V

V

VOLTAGE CURRENT

PSU 40-38

DC Power Supply

0 - 40V / 0 - 38A

Voltage Current

3. Make sure each unit is set to

Independent (F-93 = 0). When

using the power supplies in series,

each unit is operated individually,

and thus no unit is considered the

master or slave.

Page 111

Unit

F-93

Independent

0

4. Cycle the power on the units (reset the power).

Note

Configuration settings can be checked for both the

master and slave units by pressing the Function

key.