User manual

ANALOG CONTROL

129

Set F-94 (External output logic) in

the power on configuration

settings to 0 (High = On) or 1

(Low = On) and set F-98 (External

output control function) to 1(On).

 Be sure to cycle the power after

setting the power on

configuration settings.

Page 111

2. Press the Function key and confirm

the new configuration settings (F-

94 = 0 or 1 and F-98=1).

Function

3. The switch is now ready to set the output on or

off.

Note

When using a switch over long distances, please

use a switch relay to extend the line from the coil

side of the relay.

Switch

Relay

Line

extention

Analog

connector

Output

Terminal

If a single switch control is to be used for multiple

units, please isolate each instrument. This can be

achieved by using a relay.

Warning

Ensure the cables used and the switch exceed the

isolation voltage of the power supply. For example:

insulation tubes with a withstand voltage higher

than the power supply can be used.