User Manual

OPERATION

Basic Operation

This section describes the basic operations required to operate the

power supply.

 Setting OVP/OCP → from page 49

 C.V. mode → from page 51

 C.C. mode → from page 54

 Display modes → page 57

 Panel lock → page 58

 Remote sensing → from page 59

Before operating the power supply, please see the Getting Started

chapter, page 9.

Setting OVP/OCP Levels

The OVP level has a selectable range of 10% to

110% of the rated output voltage. The OCP

level has a selectable range 10%~ 110% of the

rated output current, alternatively the OCP

level can also be turned off. The OVP and OCP

level is set to 110% by default.

When one of the protection measures are on,

ALM is shown on the panel display. By default,

the power switch will turn off when any of the

protection levels are tripped.

ALM