User Manual

OPERATION

Clear OVP/OCP

protection

The OVP or OCP protection can be

cleared after it has been tripped by

holding the OVP/OCP button for 2

seconds.

(Only applicable when the power

switch trip setting is disabled

[F-95 = 1])

OVP/OCP

(hold)

Set to C.V. Mode

When setting the power supply to constant voltage mode, a current

limit must also be set to determine the crossover point. When the

current exceeds the crossover point, the mode switches to C.C.

mode. For details about C.V. operation, see page 21. C.C. and C.V.

mode have two selectable slew rates: High Speed Priority and Slew

Rate Priority. High Speed Priority will use the fastest slew rate for

the instrument while Slew Rate Priority will use a user-configured

slew rate.

Background

Before setting the power supply to C.V. mode,

ensure:

 The output is off.

 The load is connected.

Steps

1. Press the Function key. The

Function key will light up.

Function

2. The display should show F-

01 on the top and the

configuration setting for

F-01 on the bottom.

3. Rotate the voltage knob to change

the F setting to F-03 (V-I Mode

Slew Rate Select).

Voltage