TM ComLink™ IR 114 Parallel Port I/R Port I/R Port Power Button Power On Indicator Serial Port Battery Compartment OPERATOR’S MANUAL AC Power Adapter
Introduction The Ferret 114 ComLink I/R will link both the Ferret 14 GasLink Emissions Analyzer, and the Ferret 55 EngineLink Analyzer to an IBM compatible dot matrix printer. Using the ComLink™ IR 1. Connect the ComLink to Power. 2. Connect the printer to the ComLink parallel port using a standard printer cable. The parallel port is located on the top of the ComLink box. 3. Turn on the ComLink by pressing the Power Button. 4. Make sure the Printer is turned on, on-line, and loaded with paper. 5.
Troubleshooting Printer Difficulties The I/R LED’s are located on each side of the ComLink. Make sure the LED’s are in line of sight of each other and no more than 3 feet apart.
SAFETY PRECAUTIONS —Read All Instructions Before Using The Analyzer— Always wear eye protection when testing vehicles. Be extra careful near batteries and moving parts. Do not lay tools on a battery. Battery gas is highly explosive. If a battery explodes flush the acid away from skin with generous amounts of water. Follow up with a neutralizing solution of baking soda and then more water. Never use a wrench on the ungrounded battery terminal until the grounded one has been disconnected.
