Use Instructions

ELST026-AUM001-V0.6.2 Page 23 of 68
4. the treatment time in minutes: seconds
push on the enabled and buttons to change the timer settings
keep the button pressed to change parameter with higher velocity
5. Pushbutton to confirm the correctness of the pre-adjusted parameters
therapy output window:
(still zero values because treatment is not started yet)
6.
the effective treatment time in minutes:seconds
7. the administered electrical charge Q in milli-Coulomb (mC)
4.1.1.1 Performing the therapy in standard modes
Below are the necessary actions described that need to be taken in the correct order on both the
device and the hand piece to allow performing the treatment application.
For the visual colour feedback of the illuminated ring on the hand piece see § 4.4
Set a therapy
Procedure:
1. Press the intensity parameter field if you want to
adapt the step size of the intensity
2. Change treatment time if necessary with
the enabled and buttons
3. Push the confirm button if you agree with the
intensity step size and treatment time
4. This confirmation enables the Start button on
the hand piece. See content.
5. The green illuminated ring on the hand piece flashes very briefly.
Start and perform a therapy
Procedure:
The hand piece and its buttons function as a wired
remote control.
1. Press the Start button on the hand piece.
2. The intensity on the patient will be equal to the
pre-adjusted intensity step size value at the
treatment start. (e.g. 200 µA)
3. The effective treatment timer starts running.
The green illuminated ring on the hand piece lights up
continuously.