Owner`s manual

A A
USB Features
• Connects to PC via standard USB 1.1 or USB 2.0 connection
• PC operating systems supported: Windows Vista, Windows XP MCE, and Windows XP
• LED to indicate bind sequence and radio activity
• Connect button, pen-push type
USB Compatibility
The transceiver uses a standard USB Type A connector for connection to any standard USB
port of a computer. The transceiver is a certified USB compatible 2.0 device, running at low
speed. It is certified to run on Windows Vista, Windows XP MCE, and Windows XP.
This transceiver is compatible with the following Gyration products:
R4000 (The Music Service and Music Display functions of this remote require use of the
included R4000 RF Receiver to fully function)
Gyration Go Mouse
Gyration Go Mobile keyboard
Gyration Go Full size keyboard
Gyration Media Center Universal Remote Control
Gyration GyroTransport
Transceiver Compatibility
Matrix with Gyration Products
Programming the Remote
The RCU can be programmed to operate many brands of IR controllable devices via the
IR functions of the RCU. Devices include TVs, DVD Players, Cable/Satellite Boxes, etc.
Please see the Remote Code List for all devices supported.
Find Out If You Need to Progam the Remote
To determine whether the remote needs to be programmed to operate your device, do the
following (using the TV as an example)
1. Turn on the TV.
2. Point the remote at the TV.
3. Press the TV button.
4. Press the ON/OFF button to see if the TV responds. If the TV doesn’t respond, you must
program the remote to operate it.
Programming Methods
There are two ways to program the remote control: the Menu Based Programming Method
and the Direct Programming Method.
Menu Based Programming Method
To enter the Menu Based Programming Method, press
and hold the device mode button of the particular de-
vice to be programmed. After three seconds, the main
menu will appear on the display. All programming
steps can now be completed by following the on-screen
menu. Here is an example main menu that will be dis-
played after holding down the TV device mode button:
Direct Programming Method: The Direct Programming Method allows you to perform
one particular programming step directly, as outlined below. To program the remote control to
operate other components you may choose between Automatic Code Search and Direct Entry.
Using Automatic Code Search: The following instructions can be used to program the
RCU to operate each of your components. If you want to stop the automatic code search without
programming any of your components, press CLEAR and the indicator on the RCU turns off.
1. Turn on the device you want to operate (TV, DVD player, etc.)
2. Press and hold the device button you want to program (TV, AUX, etc.). While holding
the device button, press and hold ON/OFF button until the device button on the RCU
turns on, then release both buttons. When the RCU has successfully entered search mode
all devices buttons turn on. NOTE: This step must be completed within 2 seconds to
activate Automatic Code Search without entering the Menu Program Method.
3. Point the remote at the device.
19
20