Manual

106
GYSPOT PTI S7
Débit du liquide de refroidissement / Cooling liquid debit / Kühlüssigkeitsdurchuss Q
1 l/min
0.26 US gpm
Perte de charge du uide de refroidissement / Loss of cooling liquid / Druckverlust der
Kühlüssigkeit
∆p
3 bar
44 Psi
Force minimale de soudage / Minimum welding force / Min. regulierter Anpressdruck F
1min
100 daN
225 Lbf
Eort maximal régulé avec la pince en C / Maximum force regulated with the C clamp /
Max regulierter Anpressdruck mit C-Zange
F
max
550 daN
1236 Lbf
ICÔNES / SYMBOLS / ZEICHENERKLÄRUNG / ZEICHEN / СИМВОЛЫ / PICTOGRAMMEN
- Attention ! Lire le manuel d’instruction avant utilisation.
- Warning ! Read the instructions manual before use.
- Внимание! Прочтите инструкцию перед использованием
- ¡Cuidado! Lea el manual de instrucciones antes de su uso.
- Let op! Lees voor gebruik aandachtig de gebruiksaanwijzing door.
- Attenzione! Leggere il manuale d’istruzioni prima dell’uso.
Courant de soudage continu - Direct welding current - Gleichschweißstrom - Corriente de soldadura continua. - Постоянный сварочный ток - Gelijkstroom
A
Ampères - Amperes - Ampere - Amperios - Амперы - Ampère - Amper - Ampère
V
Volt - Volt - Volt - Voltio - Вольт - Volt
Hz
Hertz
3
- Alimentation électrique triphasée 50 ou 60Hz.
- Three-phase power supply 50 or 60Hz
- Dreiphasige Netzversorgung mit 50 oder 60 Hz
- Alimentación eléctrica trifásica 50 o 60Hz
- Трехфазное электропитание 50 или 60Гц
- Driefasen elektrische voeding 50 of 60Hz
- Alimentazione elettrica trifase 50 o 60Hz.
U 1N
- Tension d’alimentation assignée - Instructed supply voltage - Versorgungsspannung - Tensión de alimentación asignada - Номинальное напряжение питания - Nomi-
nale voedingsspanning
U LP
- Courant d’alimentation au courant permanent au secondaire - Supply current to secondary continuous current - Versorgungsstrom zu sekundärem Ruhestrom -
Corriente de alimentación a la corriente secundaria de estado estacionario - Ток питания до вторичного установившегося тока - Voedingsstroom naar secundaire
stationaire stroom - Corrente di alimentazione alla corrente secondaria di stato stazionario
S P
- Puissance permanente (au facteur de marche de 100%) - Permanent power (at a 100% duty cycle) - Dauerleistung (Einschaltdauer @100%) - Potencia permanente
(al ciclo de trabajo de 100%) - Постоянная мощность (при ПВ 100%) - Permanent vermogen (bij een inschakelduur van 100%)
S 50
- Puissance à 50% de facteur de marche - Power at 50% duty cycle - Leistung bei Einschaltdauer @ 50% - Potencia al 50 % del ciclo de trabajo - Мощность при ПВ 50
% - Vermogen bij 50% van de inschakelduur.
U 2d
- Tension continue à vide - Continued no load voltage - Leerlaufspannung - Tensión continua en vacío - Постоянное напряжение холостого хода - DC nullastspanning
I 2 CC
- Courant maximal de court-circuit secondaire - Maximal current of a secondary short circuit - Maximaler, sekundärseitiger Kurzschlussstrom - Corriente máxima de
cortocircuito secundario - Максимальный ток короткого замыкания на вторичке - Secondaire maximale kortsluitingsstroomsterkte
I 2 P
- Courant permanent au secondaire - Permanent current to secondary - Sekundärseitiger Dauerstrom - Corriente permanente en el secundario - Постоянный ток на
вторичке - Permanente secondaire stroom
e
- Plage d’écartement des bras - Arm aperture dimension - Abstandsbereich der Arme - Rango de separación de los brazos - Расстояние разжимания между
электродами плеча - Spreidingsbereik armen
- Plage de longueur des bras - Arm length dimension - Längenbereich der Arme - Zona de longitud de brazos - Пределы длины плеч - Lengtebereik armen
F max
- Force maximale de soudage - Maximum welding force - Maximale Schweißkraft - Fuerza máxima de soldadura - Максимальная сила сварки - Maximale laskracht
P1 min
- Pression d’alimentation minimale - Minimum input pressure - Minimaler Versorgungsdruck - Presión mínima de alimentación - Минимальное давление подачи -
Minimale voedingsdruk
P1 max
- Pression d’alimentation maximale - Maximum input pressure - Maximaler Versorgungsdruck - Presión máxima de alimentación - Максимальное давление подачи -
Maximale voedingsdruk
Q
- Débit assigné du uide de refroidissement - Cooling liquid debit instructed - Nominaler Kühlüssigkeitsdurchuss - Caudal asignado del uido de refrigeración -
Номинальный расход охлаждающей жидкости - Nominale toevoer koelvloeistof
∆p
- Perte de charge assignée du uide de refroidissement - Loss of charge of the cooling liquid instructed - Nominaler Druckverlust der Kühlüssigkeit<s - Pérdida de carga
asignada del uido de refrigeración - Номинальная потеря зарядки охлаждающей жидкости - Nominaal verlies koelvloeistof
m
- Masse de la machine - Mass of the machine - Gewicht des Geräts - Masa de la máquina - Масса аппарата - Gewicht van het apparaat
- Groupe froid - Cooling unit - Kühleinheit - Grupo de refrigeración - Система охлаждения - Koelgroep
Sortie d’eau - Water outlet - Kühlmittelausgang - Salida de agua - Выход жидкости - Uitgang water
Entrée d’eau - Water inlet - Kühlmitteleingang - Entrada de agua - Вход жидкости - Ingang water
MAXI
Niveau maximum d’eau - Maximum water level - Maximaler Kühlmittelstand - Nivel máximo de agua - Максимальный уровень жидкости - Maximale waterniveau
MINI
Niveau minimum d’eau - Minimum water level - Minimaler Kühlmittelstand - Nivel mínimo de agua - Минимальный уровень жидкости - Minimale waterniveau