Manual

45
GYSPOT PTI S7
EN
Identication mode
If the identication mode is set to «ON», all mandatory elds in the repair order must be entered to
allow the weld to go ahead or the machine will display «identication fault».
To activate and deactivate the identication mode, an SD identication card must be inserted in the
BP card reader instead of the SD card containing the programs.
The settings screen is activated by pressing and holding down the button for 2 seconds.
When the SD card «identication» is inserted and «identication ON» is selected, the supervision
screen is displayed.
This screen is used to make the elds «registration, vehicle make, vehicle model, vehicle model,
chassis number» mandatory elds when entering the repair order.
To exit the screen, press the button for 2 seconds. Then, it is necessary to put the SD card
containing the programs back into the machine card reader.
List of screens used to enter a repair order :
If a repair order has already been created, it cannot be changed or deleted on the machine. To delete it, use the Gyspot software on the PC. The user
can create a maximum of 100 repair orders.
Repair order User identication Registration (optional)
Vehicle make Vehicle model Chassis number (optional)
The arrow keys ( or ) are used to change the letters or numbers. The keys - and + are used to move the cursor inside the
eld. Press the button briey to clear the eld. The button allows you to scroll through the elds for editing or reading.
Catalogue
The button is used to consult the repair orders. The page number is displayed (max. 13)
The keys - and + are used to change pages. The keys et are used to select previous or next
job. The button displays the selected repair order.
The button key is used to exit the report view mode.