Manual

12
NOMAD POWER PRO 12 XL / 24 XL
EN
Translation of the original instructions
OUTPUT
ON/OFF
12V
OUTPUT
USB
5V/2.1A
USB
5V/2.1A
Charging
18V/2A
Error
1 - Plug the car adaptor (11) to the vehicle’s cigarette lighter socket.
2 - Connect the other end of the adapter to the 18 V/2 A charging port (7) of the NOMAD
POWER to start charging.
STRAP FASTENING
Put the NOMAD POWER on a at surface. Secure it by inserting the safety strap into the
handle and attaching it securely to the vehicle using the carabine hook provided.
USE AS A BOOSTER
RECHARGE THE NOMAD POWER before rst use and after each use.
Before use, make sure that the NOMAD POWER is charged to at least 50% of its load capacity. A charged
booster guarantees vehicle starting and allows the 118.4 Wh (PRO 12 XL) / 236.8 Wh (PRO 24 XL) to be
used to charge a wide range of accessories.
1
Switch on the booster by pressing the main switch (2), it becomes illuminated and the
display lights up.
2
OUTPUT
ON/OFF
12V
OUTPUT
USB
5V/2.1A
USB
5V/2.1A
Charging
18V/2A
Error
Disconnect the red and black clamps from the booster. A ashing red and green «8» appears
on the display. It indicates that the charger is looking for a battery.
3
1- Connect the red clamp to the (+) of the battery.
2- Connect the black clamp as far as possible from a fuel hose or tting and as close as
possible to the starter ground.
The LED indicator shows a green «8» to indicate that the battery is detected and properly
connected.
If the LED (8) lights up and a red «8» appears on the display, it means that there
is an error that needs to be corrected. Refer to the fault codes (PRO 12 XL) or the
table «Troubleshooting» (PRO 24 XL) of this manual.
5
Turn the ignition key to the on position and start the engine.
6
After starting, disconnect the battery clamps from the battery and replace the clamps on the
booster.
!
Leave the vehicle running.