Manual

13
NOMAD POWER PRO 12 XL / 24 XL
EN
Translation of the original instructions
7 Turn the unit off.
USE OF THE BOOSTER’S INTERNAL BATTERY
When the vehicle battery is too discharged, the booster battery can be used as a power source for starting. Proceed
as follows:
1. Disconnect the engine block terminals from the vehicle battery.
2. Connect the terminals of the engine block to the clamps of the nomad power. The booster does not detect a battery,
a ashing red and green «8» appears on the display.
3. Press the on button (4) for 3 seconds. The led indicator displays a green «8» to indicate that the nomad power’s
lithium battery is becoming the vehicle’s primary power source.
4. Performing a start. The engine uses the power from the nomad power pro xl’s lithium battery for starting.
5. Reconnect the terminals of the engine block to the vehicle battery.
Once the vehicle is started, the engine block must always be powered by a battery.
The connection of the engine block terminals to the vehicle battery must be made before
disconnecting the NOMAD POWER clamps from the terminals.
CHARGING MOBILE PHONES
The NOMAD POWER is equipped with two USB ports (6) and a 3-in-1 (USB-C, Micro USB connections) (13) offering
exibility for most phones or tablets. Additional standard USB accessories can also be used (not included).
OUTPUT
ON/OFF
12V
OUTPUT
USB
5V/2.1A
USB
5V/2.1A
Charging
18V/2A
Error
1 - Turn the main switch (2) to the «ON» position.
2 - Connect the supplied 3-in-1 USB cable.
3 - Connect it to the electronic device to be recharged: tablet, mobile phone...
POWER SUPPLY
For 12V vehicle products
1- Connect the supplied 12 V cigarette lighter cable to one of the two 12 V
cigarette lighter ports (1).
2 - Link the power supply cable to the power socket of your 12 V electrical
device.
For 12V vehicle products
1 - Connect a 12 V power supply cable (not supplied) to the 12 V / 3.5 A
output port (5).
2 - Link the power supply cable to the power socket of your 12 V electrical
device.