Manual

14
NOMAD POWER PRO 12 XL / 24 XL
EN
Translation of the original instructions
FLASHLIGHT FUNCTION
Press the ON/OFF button on the LED (9) to activate the lighting.
Each new press changes the lighting mode (3 available modes: normal,
strobe light, SOS) until the light goes out.
FAULT CODES (PRO 12 XL)
Reverse polarity Timed out High temperature Low temperature
High current Low current Short circuit
Unit is not
activating
PROBLEM SOLVING (PRO 24 XL)
Troubleshooting Causes Solutions
The screen is black and shows nothing. Sleep mode is on.
Press the ON/OFF button or toggle the main
switch to the OFF then ON position. The
screen lights up again.
Each connection causes a ashing red and
green "8" to appear on the display.
The booster doesn't detect a battery.
Turn on the lights or the radio so that the
NOMAD POWER detects a current load and
activates.
A xed red "8" appears on the LCD screen
when the clamps are connected and an
alarm sounds.
The device detects a polarity reversal.
Check the battery polarity. Red clamp to the
positive battery terminal (+) and the black
clamp to the negative (-).
Thermal protection of the booster.
The charger is overheated because the am-
bient temperature is high. Wait a few minutes
for the booster to cool down before trying to
start again.
Short circuit. Damaged battery. Change the battery.
A xed red "8" appears on the LCD screen
as soon as the booster switches on.
The battery is heavily discharged (<4V). Replace the vehicle battery.
WARRANTY
The warranty covers faulty workmanship for 2 years from the date of purchase (parts and labour).
The warranty does not cover:
• Transit damage.
• Normal wear of parts (eg. : cables, clamps, etc..).
• Damages due to misuse (power supply error, dropping of equipment, disassembling).
• Environment related failures (pollution, rust, dust).
In case of failure, return the unit to your distributor together with:
- The proof of purchase (receipt etc ...)
- A description of the fault reported