Manual

PPi Dual Drive

8 Maintenance and cleaning

1 Handle screws

2 Swivel connector

3 Velcro

cover

4 Electrical harness

connector

5 Cable screws

6 O-rings

Fig. 7 Cable replacement

8.4 Cable replacement

1. Remove the three rear most screws (1) in the handle, and pull back on the

cable swivel connector to disengage it from the handle.

2. Open the Velcro

cover (3) for about two feet behind the swivel connection

and then pull the swivel connection back about one foot from the handle.

3. Remove the tape covering the electrical harness connector and disconnect the

electrical harness at the handle by depressing the connector tab (4) on the cable

side connector and pulling rearward on the cable side electrical harness. NOTE:

Use .035” or smaller wire, paper clip or similar to depress the connector tab.

4. With a ball end 4 mm Allen wrench, remove the two screws (5) securing the

front cable block to the handle assembly.

5. Pull rearward on the cable assembly to disengage it from the handle assembly.

6. Reverse procedure to install new cable and be sure to grease the cable O-rings

(6). NOTE: The 4mm Allen screw torque value is 64 in lbs.