Manual

PPi Dual Drive

Note

• Newunusedlinershavetobeshortenedtotheactuallengthofthe

cable assembly.

4.3 Installing the cable liner

To be used for aluminum, copper, nickel and stainless steel wires.

PPi DUAL DRIVE

1 Torch neck

2 Inlet guide

3 Rear connector

4 O-ring

5 Liner collet

6 Retention nut

7 Liner

8 Cable assembly

Fig. 3

Installing Cable Liner:

1. Laying torch out straight remove retention nut (6) from rear connector, then

insert the liner (7), tapered end first, all the way into torch until it stops. You

should see the liner through the hole in the inlet guide (2), which will help you

to make sure liner is fully installed.

2. While torch is still laying out straight adjust the O-ring (4) and collet (5) so

that they will fit up inside of the rear connector when retention nut is installed.

There should be a slight compression on the cable liner once installed.

3. Reinstall the retention nut (6) securely, then trim rest of liner (7) as close as

possible to the feeder drive rolls or outlet guide.

Note: In case of Euro connection torches, liners smaller than 4.3mm OD should

be fitted with the hollow brass support tube which is included with the Binzel

Euro adaptor kits.