Operation Manual

GYSFLASH 40-12 FV

Shortcut to Lock Showroom :

The «Lock Showroom» feature can be activated without accessing the conguration menu.

• Turn OFF the device (main switch in the OFF position)

• Press MODE key

MODE

• Turn ON the switch, while the MODE key is still pressed. The screen displays «GYSFLASH 40-

12 FV Vx.x» for 3 seconds.

• Hold the MODE key until the creen displays «lock showroom: Y»

• Cables calibration :

This mode must be used each time the cables are changed. The GYSFLASH can be tted with cables up to

2x5m in 16mm².

OK : The calibration was successful.

FAIL : A problem occurred during the calibration. In this case, the calibration is reset to the factory setting.

Check that the cables are in good condition and properly put in short-circuit and repeat the procedure.

• ADVANCED MENU (code 1-9-6-4) :

This menu is intented for experimented user only.

To access this menu, enter in the code above («Select» key to change the digit selection and «Start/Stop» key to

conrm the code).

For more details, see page 15.

• Reset Memory (code 1-9-6-4) :

This menu is intented to factory reset the charger

settings by entering the code above. Any personal

parameters are deleted.

RESET MEMORY

Code OK

Yes

RESET MEMORY

Reset all ?

RESET MEMORY

Code: 0000

Code OK

(1964)

RESET MEMORY

Error Code

Code NOK

Display 1s

...

Change the

code number