Technical Specifications

H&C Products Group Technical Service 1.800.867.8246 Page 2 of 3
101 W. Prospect Avenue www.hcconcrete.com
Rev. 6/15
Cleveland, Ohio 44115 PDS ID: 70.000012
APPLICATION INSTRUCTIONS
For best results, apply H&C® Natural Look Satin Sealer when
air and concrete surface temperatures are above 50°F and
below 95°F. Temperature should not fall below 40°F for 24
hours following application. Do not apply if rain is expected
within 12 hours
How to Apply: Apply with a brush, roller, or airless sprayer.
When spraying, back roll sealer to remove excess, which will
ensure an even finish. Freshly stained or painted surfaces will
require cure time before sealer application. Refer to the
product instructions for minimum recoat time. The sealer will
apply milky white and dry clear in approximately 1 hour. Do
not thin. One coat of H&C® Natural Look Satin Sealer on a
porous surface will result in a satin finish.
Additional Coats: Apply second coat crosswise to the first
coat. Two coats are usually sufficient. However, extremely
porous surfaces may require a third coat for a uniform
appearance. Allow 2 hour dry time between each coat. Allow
72 to 96 hours under good drying conditions before using the
surface for heavy traffic or vehicle traffic. Multiple coats of
H&C® Natural Look Satin Sealer will result in a higher sheen
finish.
SLIP RESISTANCE
Some surfaces such as inclined driveways, garages, steps, and
patios may require a slip-resistant additive for safety. If more
than two coats are applied, consider using a slip-resistant
additive in the final coat.
CLEANUP
Clean tools and any spills or spatters immediately using soap
and warm water.
MAINTENANCE
Clean light to moderately soiled surfaces with a 50/50
solution of a cleaner degreaser and water or with another
neutral-based cleaner, following the manufacturer’s
directions for use. Use the cleaner full strength for heavy
soiling, such as oil and grease stains.
PHYSICAL PROPERTIES
Physical Properties and Characteristics
Property
Test Method
Value
Dry Time (@ 77°F, 50% RH) Dry-to-touch 1 hour
Foot/light traffic
24 hours
Heavy traffic
72-96 hours
Recoat 2 hours
VOC
EPA Method 24
98 g/L
Static Coefficient of Friction Without SharkGrip
With SharkGrip
0.7
0.85
Finish ASTM D523 Satin
Taber Abrasion
Good after 1 week
cure time
Chemical Resistance
ASTM D1308
Good
Volume Solids
ASTM D2832
29.9% +/-1%
Weight Solids ASTM D2832 26.4% +/-1%
Weight per Gallon ASTM D1475 8.57 lb/gal
ORDERING INFORMATION
Clear Part Number
1 gallon 70.000012-16
5 gallon 70.000013-20
CAUTION
CAUTIONS: Use only with adequate ventilation. To avoid
overexposure, open windows and doors or use other means to
ensure fresh air entry during application and drying. If you
experience eye watering, headaches, or dizziness, increase
fresh air, or wear respiratory protection (NIOSH approved) or
leave the area. Avoid contact with eyes and skin. Wash hands
after using. Keep container closed when not in use. Do not
transfer contents to other containers for storage. FIRST AID: In
case of eye contact, flush thoroughly with large amounts of
water. Get medical attention if irritation persists. If swallowed,
call Poison Control Center, hospital emergency room, or
physician immediately. DO NOT TAKE INTERNALLY. KEEP OUT
OF THE REACH OF CHILDREN.