Technical Specifications
H&C Products Group Technical Service 1.800.867.8246 Page 3 of 3
101 W.Prospect Avenue www.hcconcrete.com
Rev. 6/15
Cleveland, Ohio 44115 PDS ID: 72.000010
MAINTENANCE
Clean light to moderately soiled surfaces with a 50/50
solution of a Cleaner Degreaser and water or with another
neutral-based cleaner, following the manufacturer’s
directions for use. Use the cleaner full strength for heavy
soiling, such as oil and grease stains.
ORDERING INFORMATION
Bombay Part Number
1 gallon 72.000010-16
Gull Gray Part Number
1 gallon 72.000012-16
White Base Part Number
1 gallon 72.000014-16
Deep Base Part Number
1 gallon 72.000016-16
Ultra Deep Part Number
1 gallon 72.000018-16
CAUTION
CAUTIONS: CONTAINS CRYSTALLINE SILICA. Use only with
adequate ventilation. To avoid overexposure, open windows
and doors or use other means to ensure fresh air entry during
application and drying. If you experience eye watering,
headaches, or dizziness, increase fresh air, or wear
respiratory protection (NIOSH approved) or leave the area.
Adequate ventilation required when sanding or abrading the
dried film. If adequate ventilation cannot be provided wear an
approved particulate respirator (NIOSH approved). Follow
respirator manufacturer’s directions for respirator use.
Avoid contact with eyes and skin. Wash hands after using.
Keep container closed when not in use. Do not transfer
contents to other containers for storage. FIRST AID: In case of
eye contact, flush thoroughly with large amounts of water. Get
medical attention if irritation persists. If swallowed, call Poison
Control Center, hospital emergency room, or physician
immediately. DELAYED EFFECTS FROM LONG TERM
OVEREXPOSURE. Abrading or sanding of the dry film may
release crystalline silica which has been shown to cause lung
damage and cancer under long term exposure. WARNING: This
product contains chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm.
DO NOT TAKE INTERNALLY. KEEP OUT OF THE REACH OF
CHILDREN.
LIMITED WARRANTY
Seller’s and manufacturers only obligations shall be to replace
such quantity of product proved to be defective. Neither seller
nor manufacturer shall be liable for any injury, loss or damage,
direct or consequential, arising from the applicator’s inability to
use the product for his/her intended use. The user assumes all
risk and liability.
TECHNICAL SERVICES
The information and recommendations set forth in this product
data sheet are based on tests conducted by or on behalf of
H&C® Products Group and The Sherwin-Williams Company.
Such information and recommendations set forth herein are
subject to change and pertain to the product offered at the
time of publication. Consult your H&C® or Sherwin-Williams
representative to obtain the most recent product data sheet.
For technical assistance, call 1-800-867-8246 or visit
www.hcconcrete.com.